1/8/2023 0 Comments Teamviewer 11 linux![]() The configuration is generated on the first run. TeamViewer uses a different configuration for installed and uninstalled. Very little debugging information is provided when launching. You can check them but I found them to be unreadable. Several patches are included that cover many bugs with Arch Linux. It works everywhere I use it including Manjaro with any of the included versions. I read this thread and try to comment out NetworkManager in service file but problem is still here.ītw restart/stop of service or start of teamviewer takes a long time (2 minutes) Nov 18 09:42:24 dimmubox systemd: Started TeamViewer remote control daemon. ![]() Nov 18 09:42:24 dimmubox systemd: rvice: PID file /run/teamviewerd.pid not readable (yet?) after start: No such file or directory Nov 18 09:42:24 dimmubox systemd: Starting TeamViewer remote control daemon. ![]() Nov 18 09:42:24 dimmubox systemd: rvice: Failed with result 'signal'. Nov 18 09:42:24 dimmubox systemd: rvice: Unit entered failed state. └─18119 /opt/teamviewer9/tv_bin/teamviewerd -d Process: 18116 ExecStart=/opt/teamviewer9/tv_bin/teamviewerd -d (code=exited, status=0/SUCCESS)ĬGroup: /system.slice/rvice Loaded: loaded (/usr/lib/systemd/system/rvice enabled vendor preset: disabled)Īctive: active (running) since Wed 09:42:24 CET 5s ago
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |